7 Easy Steps to Make Cannabutter

The best cannabutter in America, you ask? It’s easy. Follow the directions, and you will make the best butter your weed will allow.

The truth is however, the butter is just as good as the weed you make it with. Some people like to make a mild butter and use it to spread on their toast in the morning or at a teaspoon or two to a baked potato. But seriously, the stronger the weed the stronger the butter, so plan accordingly.

Cannabutter in 7 Easy Steps:

1. Decarb Your Cannabis

To make cannabutter like a pro, heat should be applied to the cannabis first to fully activate the THC, a process known as decarboxylation.

You might need to check out our guide on How to Properly Decarboxylate Your Cannabis

2. In a medium saucepan bring a quart of water to a boil on the stove.

You can vary the amounts, just be sure that the marijuana is always floating about 1 1/2 to 2 inches from the bottom of the pan. When the water is boiling place the butter in the pan and allow it to melt completely. My recipe uses 4 sticks of butter to every 1 ounce of marijuana, so if you’re using a 1/2 ounce of weed that’s about 2 sticks of butter.

3. Once the butter has melted you can add the marijuana.

Once the weed is added the heat should be turned down, very low, to barely a simmer. I usually let the weed cook for around 3 hours. You can tell it’s done when the top of the mix turns from really watery to glossy and thick.

4. While the cannabutter is cooking, set up the bowl to hold the finished product.

I like to use a heatproof bowl, and some people use a plastic food container. Place a double layer of cheesecloth over the top and secure it with elastic, string or tape.

5. Strain the marijuana butter over the bowl, carefully trying not to spill.

When the saucepan is empty, undo the twine, pick up the cheesecloth from all four sides and squeeze out all of the remaining butter.

6. Allow the Cannabutter too cool for about an hour.

Place in the fridge until the butter has risen to the top layer and is solid. The THC and other properties have attached to the butter, and you are just about there.

7. Run a knife around the edge and lift the butter off.

Place upside down on your work surface and scrape off any of the cooking water. Your cannabutter is ready to roll. Enjoy!

Now, some ideas….

It’s time to get cooking. Here are a few ideas that will make good, quick use of your creation. Add a teaspoon or two to a warm maple syrup to use on pancakes or waffles. Butter bread for a Panini before grilling, and use it to sauté some asparagus in a pan with some Parmesan and garlic.